Rapid Set Flexible 55 bags of 20kg in GREY only £599.99 inc VAT

- Conforms to BS EN 12004 C2FT

Polymer modified cement based adhesive for fixing of tiles to a

variety of substrates.The product sets in 40 minutes and can

accept light foot traffic in 2 hours at 20ºC.

This cement based adhesive is suitable for fixing a variety of floor

and wall tiles such as ceramics, slate, quarries, porcelain, vitrified,

semi vitrified, limestone, terrazzo and mosaics to a variety of

surfaces without an admix.When set, the adhesive is water

resistant and is suitable for use in swimming pools.

The product can be used between 3mm and 6mm bed thickness

with up to 12mm in uneven areas. Solid bed method of fixing is

recommended for external areas.

PREPARATION:

Before commencing, all surfaces must be clean, dry and strong

enough to support the weight of the tiles and the adhesive.

Remove all loose dust, dirt, oil, grease and other contaminants

likely to affect adhesion.

UNDERFLOOR HEATING:

On concrete floors, the heating element should be embedded in

a layer of adhesive and allowed to set prior to fixing tiles.

TILE FIXING:

Add 4 Parts Flexible Rapid Set to 1 Part cold clean tap water by

weight in a clean mixing vessel. Mix to a smooth creamy consistency

either by hand or using a slow mechanical mixing paddle. Mix only

sufficient that can be used in 40 mins. Product that has started to

set must be discarded.Apply adhesive to the floor using a notched

trowel such that a continuous bed of adhesive between 3mm

and 6mm is achieved when tiles are applied.Adhesive should

also be applied to the back of deep studded tiles to cover the

studs. Ensure the adhesive is still moist when tiles are pressed

into place. Check occasionally there is good transfer of adhesive

onto the back of the tile. Clean surplus adhesive from the tiles

and joints as soon as possible as set adhesive will prove difficult

to remove later. Clean all tools after use.

GROUTING:

Should not be carried out until the adhesive has set after 2 hours

approx depending on site conditions. Granfix 1 Part Grout is

recommended.

APPLICATIONS:

New Brickwork, Blockwork and Concrete: Must be fully cured/dry

prior to tiling. Direct fixing possible provided wall is reasonably flat.

Screeds and Render: Should be left 14 days prior to fixing.

Existing Glazed Tiles, Unglazed Tiles, Quarry Tiles and Terrazzo:

Ensure tiles are firmly fixed and all surface treatments and

contamination is removed. On floors, mix 1 part Granfix Acrylic

Bonding and Priming Agent to 1 part ordinary portland cement

and apply to floor before tiling commences.

Plaster Surfaces: Ensure surface is free from any loose matter. Prime

surface with 2 neat coats, Granfix Acrylic Bonding & Priming Agent.

Plasterboard: Must be structurally sound with all movement

minimised and be able to take the weight of adhesive and tiles

(32kg/m

FLOOR MAINTENANCE:

The floor should be maintained with Granfix EasiCare products.